Product

Pudu RoboticsCleaning

PUDU BG1

BG1 combines debris collection, wet scrubbing and large water tanks for recurring hard-floor maintenance, with optional charging and water-service infrastructure.

Clean / waste: 75 / 60 L
Scrub width: 55 cm
Min passage: 85 cm

Purchase

Short-term rent

Long-term rent

RaaS

138,700SAR

Own the equipment. Configuration and project scope are confirmed in your quote.

Get a quote

Compare products

Indicative budget only, not a confirmed Saudi retail offer. Configuration, freight, tax, deployment and service are confirmed in your quotation. Rental and RaaS figures are planning estimates.

Product profile

Large-floor sweeping and scrubbing without separate runs.

Floor cleaning

Product type: Cleaning
Best for: Hospitality · Warehousing & logistics
Environment: Indoor

What it does for your operation

**PUDU BG1**BG1 combines debris collection, wet scrubbing and large water tanks for recurring hard-floor maintenance, with optional charging and water-service infrastructure.

In your operation

Bring two floor-care tasks into one route

BG1 combines sweeping and scrubbing for suitable hard floors. It is intended for sites where recurring debris collection and washing would otherwise require separate passes.

Task performance

Reduce the strip left along edges

An extending scrubbing brush follows walls and shelving more closely. Edge reach reduces manual follow-up, but tight corners and obstructed areas still need a separate cleaning plan.

Scrubbing width: 550 mm

Task performance

Carry enough water for a larger route

A 75 L clean-water tank and 60 L recovery tank support larger cleaning runs. The area completed between service stops depends on water flow, dirt level and the selected cleaning mode.

Clean / recovery tanks: 75 / 60 L

Safety & sensing

Map recurring routes through large interiors

BG1 combines LiDAR and 3D visual positioning to follow mapped cleaning routes and detect obstacles. The standard model has a maximum travel speed of 1.0 m/s.

Daily operation

Simplify the tasks around the cleaning run

The series uses accessible consumables and automatic disc-brush attachment for routine service. Optional station equipment handles water and charging; it does not remove the need for staff checks and periodic cleaning.

Site fit

Check the route, not just the floor area

BG1 requires a published minimum 85 cm passage. Docking space, turns and obstacles affect suitability. For planning, use up to 2,000 m²/h full coverage rather than the higher selective spot-cleaning figure.

Full coverage, max.: 2,000 m²/h

Operating conditions

Will it work at your site?

Indoor

Cleaning surfaces

Tile
Concrete
Artificial stone

Floor finish, condition and the required operating mode are checked during your site assessment.

Access & operating limits

Floor care: Water-resistant hard floors with compatible pads and detergent.
Access: At least 85 cm passage, with space for turns and docking.
Water station: A connected station needs water, drainage, power and servicing clearance.
Daily care: Inspect brushes, squeegee, debris bin and recovery tank.

This listing is for base BG1. Manufacturer series photography shows BG1 Pro; its sensor configuration is not the base model. Cleaning accessories and optional water-service equipment form the selected package.

Typical applications

Floor cleaning

Systems & infrastructure

Integrations and compatibility.

Manufacturer-documented connections and compatible equipment. Building interfaces are checked against your installation.

PUDU Link and call devices

Manufacturer-supported robot management and task-call accessories.

Optional elevator and gate interfaces

Building controls require a compatible interface and site-specific commissioning.

Technical specifications.

Clean-water tank: 75 L
Recovery tank: 60 L
Debris bin: 5 L
Scrubbing width: 550 mm
Width with side brushes: 708 mm
Full-coverage output: Up to 2,000 m²/h
Spot-cleaning output: Up to 6,000 m²/h; selective cleaning, not full coverage
Maximum runtime: 7.5 h
Minimum passage: 850 mm
Maximum speed: 1.0 m/s
Navigation: LiDAR + 3D VSLAM
Weight: Approximately 344 kg
Dimensions with squeegee: 1,195 × 760 × 1,303 mm
Dimensions without squeegee: 1,120 × 660 × 1,303 mm
Charging: Approximately 3 h on high-voltage input; 4.5 h on low-voltage input

Before you decide.

What is the difference between BG1 and BG1 Pro?

The manufacturer's comparison gives Pro a 3D-LiDAR configuration and a higher maximum speed. The water tanks and published cleaning widths are shared.

Can BG1 scrub carpet?

Do not use wet scrubbing on carpet. Assess it for suitable hard floors and specify a separate carpet-cleaning method.

Is a water station included?

It is an optional part of the supplied package. The quotation lists the station and any water, drainage or electrical work.

How much floor will it clean in our shift?

Calculate the route from full-coverage performance, then allow for turns, obstructions, servicing and repeat passes. Spot-cleaning figures are not full-floor rates.