Buy Short-term rent Long-term rent RaaS
Deployment and support across MENA
Pudu RoboticsCleaning
MT1 is a dry-sweeping robot for large indoor areas, combining debris recognition, selective cleaning and a removable 35 L waste bin.
Own the equipment. Configuration and project scope are confirmed in your quote.
Compare productsIndicative budget only, not a confirmed Saudi retail offer. Configuration, freight, tax, deployment and service are confirmed in your quotation. Rental and RaaS figures are planning estimates.
AI trash recognition identifies debris along patrol routes and directs cleaning where it is needed. This supports maintenance cleaning between scheduled full-area runs, rather than treating every pass as a complete floor sweep.
Dual-disc brushes feed debris into a 35 L bin, covering dust as well as items such as leaves and small bottles. MT1 is a sweeper; it does not replace wet scrubbing for adhered stains.
Full-coverage cleaning is rated up to 1,800 m²/h. Between full sweeps, spot-cleaning patrols target scattered debris, with a separate maximum rate of 6,000 m²/h.
Visual and LiDAR navigation, depth sensing and obstacle avoidance support routes through shared interiors. Narrow points, thresholds and mixed traffic need checking against the robot's route requirements.
Negative-pressure airflow and filtration help capture dust in the debris box. The bin and consumables are accessible for servicing. An automatic emptying station is optional and requires the matching waste container.
The robot returns to charge as needed. Stated runtime is 4–8 h depending on cleaning intensity, with charging taking about 3 h.
Floor finish, condition and the required operating mode are checked during your site assessment.
Indoor dry sweeping, not wet scrubbing. Specify any auto-empty station and validate debris and floor joints; 6,000 m²/h is spot cleaning, not full coverage.
Manufacturer-documented connections and compatible equipment. Building interfaces are checked against your installation.
Manufacturer platform for managing robot status and tasks.
Extend routes through compatible building equipment after installation and commissioning.
No. MT1 is a dry-sweeping model. Choose CC1 or BG1 when wet scrubbing and dirty-water recovery are required.
PUDU lists up to 1,800 m²/h in full-coverage mode. The 6,000 m²/h figure is for selective spot cleaning and must not be used as a whole-floor cleaning promise.
An optional auto-empty station is offered. Confirm the compatible robot revision, station and receiving bin in the quote; automatic charging alone does not empty rubbish.
Test your actual floor joints, ramps and litter. Fine or hazardous dust, liquids and unusual debris need a separate suitability assessment.
Compare the approaches and site requirements in these related solution guides.
We help define the right setup for your operation, from site assessment and integration to team training and ongoing support.
Equipment, installation and service responsibilities are agreed in your proposal.
Discuss your deploymentShare your task and location. We’ll help define the configuration and commercial terms.
